CyberData 011061 Especificaciones descargar pdf (Pagina 20)

Installing the VoIP V2 Paging Amplifier

Paging Amplifier Setup

Operations Guide 930324E CyberData Corporation

2.2.5 Confirm the IP Address and Test the Audio

2.2.5.1 RTFM Switch

When the Paging Amplifier is operational and linked to the network, use the Reset Test Function

Management (RTFM) switch (

Figure 2-14) on the Paging Amplifier face to announce and confirm

the Paging Amplifier’s IP Address, and test the audio to make sure that it is working.

Figure 2-14. RTFM Switch

Announcing the IP

Address

To announce a Paging Amplifier’s current IP address:

● Press and hold the RTFM switch for a couple of seconds and then release it.

Restoring the

Factory Default

Settings

To restore the factory default settings, complete the following steps:

1. Press and hold the RTFM switch until you hear the Paging Amplifier announce the words,

“restoring defaults” and “rebooting”.

2. Release the RTFM switch. The Paging Amplifier will be restored to the factory default settings.

2.2.6 Adjust the Volume

There are two ways to adjust the volume for the Paging Amplifier:

•The Speaker Volume (0-9) setting on the Device Configuration page

•The external Volume dial on the Paging Amplifier face

RTFM switch

Caution

Equipment Caution: Pressing and holding the RTFM switch for more than five

seconds will restore the V2 Paging Amplifier to the factory default settings. See

the “

Restoring the Factory Default Settings” section.

GENERAL ALERT

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 69 70

Sin comentarios

CyberData 011061 Especificaciones Pagina 20