CyberData 011095 Especificaciones descargar pdf (Pagina 22)

Installing the VoIP V2 Loudspeaker Amplifier

Loudspeaker Amplifier Setup

Operations Guide 930360D CyberData Corporation

2.2.7 Confirm the IP Address and Test the Audio

2.2.7.1 RTFM Switch

When the Loudspeaker Amplifier is operational and linked to the network, use the Reset Test

Function Management (RTFM) switch (

Figure 2-16) on the Loudspeaker Amplifier face to announce

and confirm the Loudspeaker Amplifier’s IP Address, and test that the audio is working.

Figure 2-16. RTFM Switch

Announcing the IP

Address

To announce a Loudspeaker Amplifier’s current IP address:

1. Press and hold the RTFM switch until you hear the IP address announcement.

2. Release the RTFM switch.

Restoring the

Factory Default

Settings

To restore the factory default settings, complete the following steps:

1. Press and hold the RTFM switch until you hear the IP address announcement. Continue holding

the RTFM switch for an additional five seconds until you hear the Loudspeaker Amplifier

announce the words, “restoring defaults” and “rebooting”.

2. Release the RTFM switch. The Loudspeaker Amplifier will be restored to the factory default

settings.

2.2.8 Adjust the Volume

There are two ways to adjust the volume for the Loudspeaker Amplifier:

•The Speaker Volume (0-9) setting on the Device Configuration page

•The external Volume dial on the Loudspeaker Amplifier face

RTFM switch

Caution

Equipment Caution: Pressing and holding the RTFM switch for more than five

seconds after the IP address announcement will restore the unit to the factory

default settings. See the “

Restoring the Factory Default Settings” section.

GENERAL ALERT

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 71 72

Sin comentarios

CyberData 011095 Especificaciones Pagina 22