CyberData 011214 Especificaciones descargar pdf (Pagina 78)

Installing the VoIP Outdoor Intercom with Keypad

Intercom Setup

Operations Guide 930809M CyberData Corporation

Note You must click on the Save button and then the Reboot button for the changes to take

effect.

Current Time Sets the current time.

Note: Be sure to save the current time by clicking on the Set Time button.

Encryption Encryption can either be set to None or AES-256.

Encryption Key Sets the AES encryption key. If encryption is currently enabled, the

response to this command will be sent using the “old” key. The new key

should be sent as 64 ASCII hexadecimal characters.

Door State This field displays the current door state and is not configurable.

Relay State This field displays the current relay state and is not configurable.

Button State This field displays the current button state and is not configurable.

LED This field displays the current LED state and is not configurable.

Alarm State This field displays the current alarm state and is not configurable.

JP4, 6, 9, 10 This shows whether jumpers JP4, JP6, JP9, or JP10 are either enabled or

disabled through the four digit sequence (0000). The 0 turns to 1 for an

enabled jumper. For example, 0011 would mean jumpers JP9 and JP10

are activated, but JP4 and JP9 are not.

Click on the Refresh button to refresh the Device Configuration page.

Click on the Get Log button to get a log of the associated door strike relay

activity. The door strike relay has 128Kb non-volatile storage for log data,

storing an average of 10 days' worth of log data before it is overwritten.

Click on the Clear Log button to clear the log from the door strike relay

Click on the Reboot button to reboot any “discovered” remote relays and

clear any associated devices.

Click on the Set Time button to change the time.

Click on the Save Changes button to save any changes that are made to

the Device Configuration page.

Note: The time setting must be saved by pressing the Set Time button.

Click on the Cancel button to cancel any changes that were made to the

Configure Device page and return to the DSR page.

Click on the Browse button to navigate through your computer and find

firmware files.

Click on the Upgrade button to upgrade the firmware of the door strike

relay.

Table 2-22. DSR Page Device Configuration Parameters (continued)

Web Page Item Description

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 118 119

Sin comentarios

CyberData 011214 Especificaciones Pagina 78