CyberData 011272 Especificaciones descargar pdf (Pagina 24)

Operations Guide 930853D CyberData Corporation

Installing the VoIP Flush-Mount Indoor Intercom

Intercom Setup

2.3.6.2 Restoring the Factory Default Settings

When troubleshooting configuration problems, it is sometimes convenient to restore the device to a

known state.

Note Each Intercom is delivered with factory set default values.

To restore the factory default settings:

1. Press and hold the RTFM button (see SW1 in Figure 2-11) for more than five seconds.

2. The device announces that it is restoring the factory default settings.

Note The device will use DHCP to obtain the new IP address (DHCP-assigned address or default

to 10.10.10.10 if a DHCP server is not present).

Figure 2-11. RTFM Button

2.3.7 Adjust the Volume

You can adjust the volume through the SIP Volume, Multicast Volume, Ring Volume, and Sensor

Volume settings on the Device Configuration Page.

RTFM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 85 86

Sin comentarios

CyberData 011272 Especificaciones Pagina 24