CyberData 011171 Especificaciones descargar pdf (Pagina 51)

Mount the VoIP Zone Controller

Operations Guide 930446E CyberData Corporation

A.1.2 Mounting Procedure

To mount the VoIP Zone Controller:

1. On the mounting location, mark and then drill two 3/16-inch (0.1875-inch) holes 3.5 inches

apart from and parallel to each other for the plastic-ribbed anchors and screws. See

Figure A-1.

2. Insert the plastic-ribbed anchors into the prepared holes. See Figure A-1.

3. Install the #6 screws into the plastic-ribbed anchors and leave approximately 1/8-inch gap from

the screw head to the wall. See

Figure A-1.

4. Determine which sides of the VoIP Zone Controller will be facing up, and then slide the VoIP

Zone Controller down over the screws to latch onto the screws.

Figure A-1. Mounting

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 57 58 59

Sin comentarios

CyberData 011171 Especificaciones Pagina 51