CyberData 011280 Especificaciones descargar pdf (Pagina 27)

Installing the Singlewire Paging Adapter

Configure the Device Parameters

Operations Guide 930729A CyberData Corporation

On the Network Configuration page, enter values for the parameters indicated in Ta bl e 2-7.

On this page:

1. Specify whether you use Static or DHCP IP Addressing by marking the appropriate radio

button. Then, if you select Static, go to

Step 2.

2. For Static IP Addressing, also enter values for the following parameters:

• The Singlewire Paging Adapter’s IP Address: The Singlewire Paging Adapter is delivered

with a factory default IP address. Change the default address to the correct IP address for

your system.

Table 2-7. Network Configuration Parameters

Web Page Item Description

Stored Network Settings Shows the settings stored in non-volatile memory.

IP Addressing Select either DHCP IP Addressing or Static IP Addressing by

marking the appropriate radio button. If you select Static, configure

the remaining parameters indicated in

Table 2-7. If you select DHCP,

go to Step 3.

IP Address Enter the Static IP address.

Subnet Mask Enter the Subnet Mask address.

Default Gateway Enter the Default Gateway address.

DNS Server 1 Enter the DNS Server 1 address.

DNS Server 2 Enter the DNS Server 2 address.

VLAN ID (0-4095) Enter the VLAN ID number.

Note: The device supports 802.11Q VLAN tagging support. The

switch port connected to the device will need to be in “trunking mode”

for the VLAN tags to propagate.

VLAN Priority (0-7) Enter the VLAN priority number.

DHCP Timeout

DHCP Timeout in seconds Enter the desired timeout duration (in seconds) that the device will

wait for a response from the DHCP server before defaulting back to

the stored static IP address.

Note: A value of -1 will cause the device to retry indefinitely and a

value of 0 will cause the device to reset to a default of 60 seconds.

Current Network Settings Shows the current network settings.

IP Address Shows the current Static IP address.

Subnet Mask Shows the current Subnet Mask address.

Default Gateway Shows the current Default Gateway address.

DNS Server 1 Shows the current DNS Server 1 address.

DNS Server 2 Shows the current DNS Server 2 address.

Click the Save button to save your configuration settings.

Note: You need to reboot for changes to take effect.

Click on the Reboot button to reboot the system.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 44 45

Comentarios a estos manuales

Sin comentarios

CyberData 011280 Especificaciones Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores CyberData 011280