CyberData SiP Compliant 010846 Especificaciones descargar pdf (Pagina 22)

CyberData Corporation 930098C VoIP Paging Gateway Operations Guide

Implementing the VoIP Paging Gateway

On this page:

1. Specify whether you use Stat

ic or DHCP IP Addressing by marking the appropriate radio

button. Then, if you select Static, go to Step 2.

Note Cha

ging the IP Addressing selection causes the system to reboot when click Save Settings.

2. For Static IP Addressing, also enter values for the following parameters:

a. The VoIP Paging Gateway’s IP Address:

The V

oIP Paging Gateway is delivered with a

factory default IP address. Change the default address to the correct IP address for your

system.

Note Changing the V

oIP Paging Gateway’s IP Address causes the system to reboot when you

click Save Settings.

b. The Subnet Mask.

The Default Gateway.

Click Save Settings when

you finish.

2.4.4 Change the Default Username and Password

On the Home page, click Gateway Setup to open the Gateway Configuration page. After changing

the Username and Password on this page, new browser requests require you to log in using these

new parameters.

Note You can

also run an audio test from this page, as described in Section 2.4.5, "Broadcast a Test

Message to a Specific Paging Zone".

Link to the Upgrade Firmware web page.

Link to the Home page.

Table 2-2. Network Setup Parameters (continued)

Web Page Item Description

VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 37 38

Sin comentarios

CyberData SiP Compliant 010846 Especificaciones Pagina 22