CyberData 011035 Especificaciones descargar pdf (Pagina 24)

Installing the VoIP Emergency Intercom

RTFM Button

Operations Guide 930279W CyberData Corporation

2.2.6 RTFM Button

GENERAL ALERT

Caution

Your intercom will have either an RTFM button or two jumper pins labeled JP11

on the circuit board. If your intercom does not have an RTFM button, use JP11

for IP address announcement and factory reset functions. You will need a

jumper shunt to place over the JP11 jumper pins per the instructions below.

When the Intercom is operational and linked to the network, use the Reset Test Function

Management

(RTFM) button (see SW1 in Figure 2-8) or place a jumper shunt on the JP11 jumper

pins (see JP

11 in Figure 2-9) on the Intercom board to announce and confirm the Intercom's IP

Address and test the audio is working. Your intercom will

have an RTMF button or a JP11 jumper

but not both.

Note You must

do these tests prior to final assembly.

Figure 2-8. RTFM Button

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 90 91

Sin comentarios

CyberData 011035 Especificaciones Pagina 24