CyberData 010935 Especificaciones descargar pdf (Pagina 27)

Installing the VoIP Intercom

Intercom Setup

Operations Guide 930242AB CyberData Corporation

2.1.7.2 Intercom with a Jumper and No RTFM Button

1. If you have an Intercom with a jumper and no RTFM button, then install a jumper on JP11. See

JP11 in

Figure 2-11.

2. Wait until the IP address is announced.

3. Remove the jumper and restart the unit.

Figure 2-11. Jumper on JP11

2.1.8 Restore the Factory Default Settings

When troubleshooting configuration problems, it is sometimes convenient to restore the device to a

known state. To restore the factory default settings on your device, do one of the following:

• If you have an Intercom that has an RTFM Button, then see Section 2.1.8.1, "Intercom with an

RTFM Button".

• If you have an Intercom that has a jumper and does not have an RTFM button, then see Section

2.1.8.2, "Intercom with a Jumper".

Note Each Intercom is delivered with factory set default values.

Note The device will use DHCP to obtain the new IP address (DHCP-assigned address or default

to 10.10.10.10 if a DHCP server is not present).

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 92 93

Sin comentarios

CyberData 010935 Especificaciones Pagina 27