CyberData 010935 Especificaciones descargar pdf (Pagina 49)

Installing the VoIP Intercom

Intercom Setup

Operations Guide 930242AB CyberData Corporation

2.2.7 Configure the Sensor Configuration Parameters

The door sensor (pins 5 and 6) on the header can be used to monitor a door's open or closed state.

There is an option on the Sensor Configuration page to trigger on an open or short condition on

these pins. The door sensor alarm will be activated when the Door Open Timeout parameter has

been met.

The intrusion sensor is an optical sensor installed on the Intercom board and will be activated when

the Intercom is removed from the case.

For each sensor there are four actions the Intercom can take:

• Flash the LED until the sensor is deactivated (roughly 10 times/second)

• Activate the relay until the sensor is deactivated

• Loop an audio file out of the Intercom speaker until the sensor is deactivated

• Call a preset extension and play a pre-recorded audio file (once)

Note Calling a preset extension can be set up as a point-to-point call, but currently can't send

delayed DTMF tones.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 92 93

Sin comentarios

CyberData 010935 Especificaciones Pagina 49