
Installing the VoIP Intercom
Intercom Setup
Operations Guide 930242AB CyberData Corporation
24
2.1.8.2 Intercom with a Jumper
Complete the following steps to restore defaults on an Intercom that has a jumper and no RTFM
button:
1. Put a jumper on JP11. See Figure 2-14.
Figure 2-14. Jumper on JP11
2. Wait for the Intercom to announce the IP address.
3. Press and hold the Call Button (see Figure 2-15) until "
restoring defaults
" is announced.
4. Release the Call Button and wait for the Intercom to reboot.
5. Remove the jumper and cycle power by unplugging Intercom and plugging it back in.
Comentarios a estos manuales