CyberData 011186 Manual de usuario descargar pdf (Pagina 36)

Operations Guide 930796L CyberData Corporation

Installing the VoIP Outdoor Intercom

Intercom Setup

DTMF Activation Code Activation code used to activate the relay when entered on

a phone during a SIP call with the device. Activate Relay

with DTMF Code must be enabled. Enter up to 25 digits 

(* and # are supported).

DTMF Activation Duration (in seconds) The length of time (in seconds) during which the relay will

be activated when the DTMF Activation Code is detected.

Enter up to 5 digits.

NOTE: A DTMF activation duration of 0 will toggle the

relay indefinitely or until the activation code is sent again

Play tone during DTMF Activation

When selected, the device will play a tone out of the

speaker upon DTMF relay activation. The tone plays for

the DTMF Activation Duration (in seconds).

Activate Relay During Ring

When selected, the relay will be activated for as long as

the device is ringing. When Auto-Answer Incoming Calls is

enabled, the device will not ring and this option does

nothing.

Activate Relay During Night Ring

When selected, the relay will be activated as long as the

Nightringer extension is ringing.

Activate Relay While Call Active

When selected, the relay will be activated as long as the

SIP call is active.

Activate Relay on Button Press

When selected, the relay will be activated when the Call

button is pressed.

Relay on Button Press Duration

The length of time (in seconds) during which the relay will

be activated when the Call button is pressed. Enter up to 5

digits. A Relay on Button Press Duration value of 0 will

pulse the relay once when the Call button is pressed.

Clock Settings

Set Time with NTP Server on boot When selected, the time is set with an external NTP

server when the device restarts.

NTP Server

Use this field to set the address (in IPv4 dotted decimal

notation or as a canonical name) for the NTP Server. This

field can accept canonical names of up to 64 characters in

length.

Posix Timezone String

See Section 2.4.5.1, "Time Zone Strings" for information

about how to use the Posix Timezone String to specify

time z

one and daylight savings time where applicable.

Enter up to 63 characters.

Periodically sync time with server

When selected, the time is periodically updated with the

NTP server at the configured interval below.

Time update period (in hours)

The time interval after which the device will contact the

NTP server to update the time. Enter up to 4 digits.

Current Time

Allows you to input the current time. (6 character limit)

Misc Settings

Device Name Type the device name. Enter up to 25 characters.

Table 2-7. Device Configuration Parameters (continued)

Web Page Item Description

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 115 116

Comentarios a estos manuales

Sin comentarios

CyberData 011186 Manual de usuario Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta CyberData 011186