CyberData 011186 Manual de usuario descargar pdf (Pagina 43)

Operations Guide 930796L CyberData Corporation

Installing the VoIP Outdoor Intercom

Intercom Setup

2. On the Network page, enter values for the parameters indicated in Tabl e 2-12.

Note The question mark icon (

) in the following table shows which web page items will be defined

after the To

ggle Help button is pressed.

Table 2-12. Network Configuration Parameters

Web Page Item Description

Stored Network Settings

Addressing Mode Select either DHCP IP Addressing or Static Addressing by marking

the appropriate radio button. DHCP Addressing mode is enabled on

default and the device will attempt to resolve network addressing with

the local DHCP server upon boot. If DHCP Addressing fails, the

device will revert to the last known IP address or the factory default

address if no prior DHCP lease was established. See Section 2.4.1,

"Factory Default Settings" for factory default settings. Be sure to click

Save and Reboot to store changes when configuring a Static

address.

Hostname This is the hostname provided by the DHCP server. See the DHCP/

DNS server documentation for more information. Enter up to 64

characters.

IP Address Enter the Static IPv4 network address in dotted decimal notation.

Subnet Mask Enter the Subnet Mask in dotted decimal notation.

Default Gateway Enter the Default Gateway IPv4 address in dotted decimal notation.

DNS Server 1 Enter the primary DNS Server IPv4 address in dotted decimal

notation.

DNS Server 2 Enter the secondary DNS Server IPv4 address in dotted decimal

notation.

DHCP Timeout in seconds Specify the desired time-out duration (in seconds) that the device will

wait for a response from the DHCP server before reverting back to

the stored static IP address. The stored static IP address may be the

last known IP address or the factory default address if no prior DHCP

lease was established. Enter up to 8 characters. A value of -1 will

retry forever.

VLAN Settings

VLAN ID (0-4095) Specify the IEEE 802.1Q VLAN ID number. Enter up to 4 digits.

Note: The device supports 802.1Q VLAN tagging support. The

switch port connected to the device will need to be in “trunking mode”

for the VLAN tags to propagate.

VLAN Priority (0-7) Specify the IEEE 802.1p VLAN priority level. Enter 1 digit. A value of

0 may cause the VLAN ID tag to be ignored.

Current Network Settings Shows the current network settings.

IP Address Shows the current Static IP address.

Subnet Mask Shows the current Subnet Mask address.

Default Gateway Shows the current Default Gateway address.

DNS Server 1 Shows the current DNS Server 1 address.

DNS Server 2 Shows the current DNS Server 2 address.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 115 116

Comentarios a estos manuales

Sin comentarios

CyberData 011186 Manual de usuario Pagina 43

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta CyberData 011186